Nonstop flight route between Rochester, Indiana, United States and Grand Forks, North Dakota, United States:
Departure Airport:
Arrival Airport:
Distance from RCR to RDR:
Share this route:
Jump to:
- About this route
- RCR Airport Information
- RDR Airport Information
- Facts about RCR
- Facts about RDR
- Map of Nearest Airports to RCR
- List of Nearest Airports to RCR
- Map of Furthest Airports from RCR
- List of Furthest Airports from RCR
- Map of Nearest Airports to RDR
- List of Nearest Airports to RDR
- Map of Furthest Airports from RDR
- List of Furthest Airports from RDR
About this route:
A direct, nonstop flight between Fulton County Airport (RCR), Rochester, Indiana, United States and Grand Forks Air Force Base (RDR), Grand Forks, North Dakota, United States would travel a Great Circle distance of 728 miles (or 1,172 kilometers).
A Great Circle is the shortest distance between 2 points on a sphere. Because most world maps are flat (but the Earth is round), the route of the shortest distance between 2 points on the Earth will often appear curved when viewed on a flat map, especially for long distances. If you were to simply draw a straight line on a flat map and measure a very long distance, it would likely be much further than if you were to lay a string between those two points on a globe. Because of the relatively short distance between Fulton County Airport and Grand Forks Air Force Base, the route shown on this map most likely still appears to be a straight line.
Departure Airport Information:
IATA / ICAO Codes: | RCR / KRCR |
Airport Name: | Fulton County Airport |
Location: | Rochester, Indiana, United States |
GPS Coordinates: | 41°3'56"N by 86°10'54"W |
Operator/Owner: | Fulton County Airport Authority |
Airport Type: | Public |
Elevation: | 790 feet (241 meters) |
# of Runways: | 1 |
View all routes: | Routes from RCR |
More Information: | RCR Maps & Info |
Arrival Airport Information:
IATA / ICAO Codes: | RDR / KRDR |
Airport Names: |
|
Location: | Grand Forks, North Dakota, United States |
GPS Coordinates: | 47°57'39"N by 97°24'3"W |
View all routes: | Routes from RDR |
More Information: | RDR Maps & Info |
Facts about Fulton County Airport (RCR):
- Because of Fulton County Airport's relatively low elevation of 790 feet, planes can take off or land at Fulton County Airport at a lower air speed than at airports located at a higher elevation. This is because the air density is higher closer to sea level than it would otherwise be at higher elevations.
- The furthest airport from Fulton County Airport (RCR) is Margaret River Airport (MGV), which is located 11,175 miles (17,984 kilometers) away in Margaret River, Western Australia, Australia.
- Fulton County Airport (RCR) currently has only 1 runway.
- The closest airport to Fulton County Airport (RCR) is Plymouth Municipal Airport (PLY), which is located 22 miles (35 kilometers) NNW of RCR.
Facts about Grand Forks Air Force Base (RDR):
- In 1973, the 319th Bomb Wing acquired the AGM-69 Short Range Attack Missile, replacing the older AGM-28 Hound Dog air-to-ground missile aboard its B-52H aircraft.
- The furthest airport from Grand Forks Air Force Base (RDR) is Margaret River Airport (MGV), which is located 10,504 miles (16,904 kilometers) away in Margaret River, Western Australia, Australia.
- The closest airport to Grand Forks Air Force Base (RDR) is Grand Forks International Airport (GFK), which is located only 10 miles (17 kilometers) E of RDR.
- Following the departure of the last B-1B aircraft in 1994, the base transferred to the new Air Mobility Command and the 319th Bomb Wing was redesignated as the 319th Air Refueling Wing.
- In addition to being known as "Grand Forks Air Force Base", another name for RDR is "Grand Forks AFB".
- On 3 November 1967, the Department of Defense revealed that GFAFB was one of 10 initial locations to host a Sentinel Anti-Ballistic Missile site.
- On 18 February 1957, the 478th Fighter Group was activated at Grand Forks.